fc-world.gif

 

EUROPICCOLA EN - november 1962 (sn 2300)

 

    CIMG4252.JPG CIMG4256.JPG CIMG4253.JPG

KEY FEATURES

   The machine was produced in November 1962 (engraved on the heating element), and recorded with serial number 2300.

CIMG3047.JPG   CIMG3181.JPG

Is the second model Europiccola, characterized by the presence of glass water level indicator, instead absent in the first model.
The machines with these features lie in the second half of 1962 and first half of 1963.


Other special features include:
• the metal boiler cap
• the group screwed to the body boiler
• the switch to two positions
• the lack of drip tray to collect water
• the holder filter with the output of coffee a circular hole
• the red logo sticker

• the blue rubber sottobase

 

DETAILS

CIMG3167.JPG

CIMG3178.JPG

CIMG3165.JPG

The cap is made of metal and screws outside the boiler

The body group is screwed directly on the boiler

The safety valve is composed of a spring and a ball of metal

CIMG3171.JPG

CIMG3166.JPG

CIMG3179.JPG

The steam tap knob is screwed to shaft and stopped by a screw

the end of the steam pipe is small and rounded

The protective metal glass layer is fixed and stop by a bolt support higher

CIMG3169.JPG

CIMG3170.JPG

CIMG3168.JPG

The piston brass has three small holes on the bottom

Inside the group is a straitjacket that brass is to shower where water comes out, is screwed in the group and a gasket seals top and bottom (sottocoppa) upon which the holder

The leverage is coming down towards the end with the holes, the pins are leveraging slightly longer than the current and smaller rings

resistenza-11-62.JPG

CIMG3176.JPG

CIMG3183.JPG

The base is in aluminum case, the heating element  is a double-filament, copper, screwed directly on the boiler

The switch in position "massimo" turn the two filaments of resistance, in a "minimo" only a filament

The cable is original, rubber, longitudinal grooves

CIMG3163.JPG

CIMG3164.JPG

CIMG4254.JPG

The holder is particularly deep and the jet has the circular exit holes

The filter 2 doses is deeper current filters

The logo is red in aluminum foil

CIMG3175.JPG

CIMG4250.JPG

CIMG3198.JPG

The plan to support the cup is slightly shaped and not has the function to collect the drops, the paint is a hammer type

sottobase is in blue rubber and hangs on aluminum base

The first coffee made for trial, after reviewing all done

(sent to Jack – Australia)

 

© 2008 Francesco Ceccarelli. All rights reserved.
Reproduction in any form without permission is prohibited
.

 www.francescoceccarelli.eu